Door Forced Open Warning & Timing; Door Propped-Up Warning & The Delay Time - AEI DK-2822 User Manual

DOOR FORCED OPEN WARNING & TIMING
LOCATION

(1) LOCATION
(1)

Key in Location
(2) FUNCTION MODES FOR DOOR FORCED OPEN WARNING
The Door Forced Open Warning function works with a Door Position Sensing switch equipped on the
door (usually a magnetic contact). Once a Timing Figure is put into the Function Mode box, the
warning mode is enabled.

--- Door Forced Open Warning OFF – (Default)

- --- Door Forced Open Warning & Alarm Enabled & Timing
The Timing Figure for the Warning can be 1-999 seconds. The keypad generates the door forced
open warning beeps and activates the alarm output (Terminal 12) instantly if the door is forced to
open without a valid User Code/Card or pressing of Egress Button. The beeps and alarm will last as
long as the time set on the timer and it can be stopped at anytime with an User Code/Card in Group
1 before the end of the time.
The Manner of The Door Forced Open Warning:
a) The door is forced to open (without using Code/Card or Egress Button) – Warning & Alarm
b) The door is opened with Code/Card – No Warning or Alarm
c) The door is opened with Egress Button – No Warning or Alarm
(3) VALIDATION
Press key once. Two-beep confirms the entry
DOOR PROPPED-UP WARNING & THE DELAY TIME
LOCATION

(1)
(1) LOCATION

Key in Location
(2) FUNCTION MODES FOR DOOR PROPPED-UP WARNING
If somebody opened the door and left it open longer than the allowable delay time, the keypad will
generate door propped-up warning until the door is re-closed. There is warning beeps from the
keypad only but it does not activate the alarm output. This function works with a door position
sensing switch equipped on the door.

--- Door Propped-up Warning OFF – (Default)

- --- Door Propped-up Warning ON & The Delay Time
The Delay Time can be 1 to 999 seconds. It is the allowed time for door open without starting
warning.
(3) VALIDATION
Press key once. Two-beep confirms the entry
(Location 80)
FUNCTION MODES VALIDATION
 
or -
(2) (3)
(Location 81)
FUNCTION MODES VALIDATION
 
or -
(2) (3)
38