Table of Contents
Advertisement
DURESS CODES (FOR OUTPUTS 1 & 2)
Duress Codes are prepared for those Important Persons in case of DURESS while he is operating
the access control keypad. The duress code operates like a normal User Code for Output 1 or 2, and
at the same time activates the Duress Output without any indication. The user may use it to report
an emergency and ask for help silently when he is forced to operate the keypad if the Duress Output
is connected with a security system (for example, an Auto-dialer).
NOTE: The Duress Codes are always valid. They are not governed by any inhibit or lockup function
in the system.
LOCATIONS
CODE ID
-
-
(1)
(2)
(1) LOCATIONS
– Duress Codes for Output 1
– Duress Codes for Output 2
(2) DURESS CODE IDs
-
50 Duress Code IDs for The Output 1
-
10 Duress Code IDs for The Output 2
= Clear all the Duress Codes from the selected Location group.
Please see the programming example below for the details.
(3) THE DURESS CODES
50 and 10 Duress Codes can be programmed for Output 1 and 2 respectively. They are stored in their
two-digit Code ID box. When a new Code is put into the same Code ID box, the old code is replaced.
The Duress Codes are 4-8 digits for Manual Mode code entry.
The Duress Codes MUST be in the same digit length with the Master Code for Auto Mode
code entry.
Always set a Duress Code that is easy to remember in Panic Situation. Only one number
different from the daily used User Code is highly recommended.
Example: User Code is 1 3 6 9, then 3 3 6 9 or 1 3 6 0 might be a good choice for the
Duress Code.
The Duress Code can also be used to replace the Secondary User Code or Common
User Code in Card reading for the Duress reporting.
(4) VALIDATION
Press
key once. Two-beep confirms the entry.
(Locations 41 & 42)
DURESS CODE
VALIDATION
4-8 DIGITS
(3)
28
(4)
Advertisement
Table of Contents
