Advertisement
Quick Links
APPLICATION EXAMPLE
BASIC WIRINGS OF A STAND ALONE DOOR LOCK
+
12 24V
12 24V
-
AC / DC
POWER
SUPPLY
AD-1312
OR AP-960
AD-2312
EGRESS BUTTON
N.O.
(INSIDE THE HOUSE)
MORE EGRESS
BUTTONS CAN
N.O.
BE CONNECTED
IN PARALLEL
NOTE:
Connect the 1N4004 as close as possible to the lock in parallel with the lock power terminals to absorb the back
EMF to prevent it from damaging the keypad. The 1N4004 is not required if the electric lock is AC operated.
To avoid Electro-Static-Discharge from interfering with the operation of the keypad, always ground the ( )
terminal of the keypad to earth.
An Innovative Product
Developed By:
MANUFACTURED BY:
AEI PROTECT - ON
SYSTEMS LIMITED
DK-9520
-
OUTPUT 1
EG
N.C. C. N.O.
IN
OUTPUT RELAY
N.C. N.O.
N.O. Output for Fail-secure Lock
OR
N.C. Output for Fail-safe Lock
ELECTRIC LOCK
1N4004
CATHODE
SINCE 1979
R
ADVANCED ELECTRONICS
INDUSTRY
12
DIGITAL ACCESS CONTROL KEYPAD
-
Programming & Installation Manual
40IN9520
M-100705
SELF-CONTAINED
DK-9520
FOR ELECTRIC LOCK INSTALLATION
Advertisement
Related Manuals for AEI DK-9520
Summary of Contents for AEI DK-9520
- Page 1 To avoid Electro-Static-Discharge from interfering with the operation of the keypad, always ground the ( ) terminal of the keypad to earth. DK-9520 Programming & Installation Manual FOR ELECTRIC LOCK INSTALLATION An Innovative Product Developed By: MANUFACTURED BY: SINCE 1979 ADVANCED ELECTRONICS AEI PROTECT - ON 40IN9520 INDUSTRY SYSTEMS LIMITED M-100705...
-
Page 2: Connection Terminals
------ Locking is reset and keypad resumes normal operation DK-9520 consists two application softwares of Single User Mode for the general Users, and Multi-User Mode for the advanced Users. The system offers a 4 digit length user code with 10,000 combinations in single user mode;... -
Page 3: The Led Indicators
2) Programming -- Set the above requirement into the keypad THE LED INDICATORS 0000 * -------------------- System has been set in programming mode with the factory-set Master Code (INHIBIT) 8901 # -------------------- System has been set for Multi User Mode** (please see NOTE (a) below) It lights up if the operation of output relay is inhibited. - Page 4 PROGRAMMING OPTIONS -- NOTE: a) **Enter the Single User Mode Command Code "8900" may not be necessary if the keypad was SUMMARY CHART already in Single User Mode. A) Use The Factory-set Master Code to Entry in Programming When starts for the first time b) In case of wrong entry during programming, cancel it with key, or, wait 10 seconds, then re-try.
- Page 5 PROGRAMMING AND USE OF THE KEYPAD -- E) Personal Safety OPERATION EXAMPLES Installer Programming Locations No. of False Entry Validation Comments A) PROCEDURES OF PROGRAMMING After 10 successive false codes, the keypad locks during 30 seconds All programming is accomplished entirely from the front of the keypad. The keypad may be programmed in After 10 successive false codes, the Duress output switches to ground your shop or at the installation site.
- Page 6 SINGLE USER MODE OR MULTI-USER MODE SELECTION SET THE SYSTEM TO MULTI-USER MODE The keypad consists two sets of software for owner's selection in user code programming. They are "Single User The system can be set to Multi Users Mode with the command code " 8901"...