Output Modes & Timing For Output 1 And 2 - AEI DK-2822 User Manual

OUTPUT MODE & TIMING FOR OUTPUT 1 & 2
The two relay outputs are programmable for Start/Stop or Timing modes. Apart from door access
control, alarm arm-disarm control, they are also universal timers for automatic operators in
industry with their 99,999 seconds (over 24 hours) programmable timer.
LOCATIONS OUTPUT MODE & TIME
  
-
(1)
(1) LOCATIONS
-- Location for Output 1
-- Location for Output 2 (DK-2822A only)
(2) OUTPUT MODE & TIMING
Start /Stop Mode (Toggle)
The number 0 sets the output to Start / Stop mode. The output Starts when an User Code
and/or Card is entered/read; the output Stops when an User Code and/or Card is
entered/read again.
-- Seconds Momentary --- (Default -- Momentary 5 Seconds)
The output can be set in Momentary Mode with the time of 1 second to
99,999 seconds. The output will reset automatically when the time
expires.
(3) VALIDATION
Press key once. Two-beep confirms the entry.
RESET OUTPUT TIMER WITH SUPER USER CODE
The Output Timer can be RESET manually at anytime with the Super User Code that operates
the desired output before the end of the time.
Example:
SUPER USER CODE
Reset Output 1 Timer --
Reset Output 2 Timer -- SUPER USER CODE
(Locations 51 & 52)
VALIDATION

or -
(2) (3)
------------- Output 1 stops
------------- Output 2 stops
31