Lan Interface Setup - Loopcomm LP-8186C User Manual

Item
Disable WPS
WPS Status
Self-PIN Number
Push Button Configuration The Start PBC button provides tool to scan the wireless network. If any
Apply Changes
Reset
Current Key Info
Client PIN Number

LAN Interface Setup

This page is used to configure the parameters for local area network that connects to the LAN ports of your WLAN
Broadband Router. Here you may change the setting for IP address, subnet mask, DHCP, etc.
Description
Click on to disable the Wi-Fi Protected Setup function.
Show WPS status is Configured or UnConfigured.
Fill in the PIN Number of AP to register the wireless distribution system
access capability.
Access Point or IBSS is found, you could connect it automatically when
client join PBC mode.
Click the Apply Changes button to complete the new configuration setting.
Click the Reset button to abort change and recover the previous
configuration setting.
Authentication：It shows the Authentication is opened or closed.
Encryption：It shows the Encryption mode.
Key：It shows the Encryption key.
Fill in the Client PIN Number from your Client sites.
29