Demo Is Only Choice On Hardware Wizard: Interface Dialog; Figure 7-3: Typical Hardware Wizard: Interface Dialog; Figure 7-4: Typical Rsconfig Dialog: Camera1 - Teledyne Princeton Instruments NIRvana System Manual

Chapter 7
7.7

Demo is only Choice on Hardware Wizard: Interface Dialog

If RSConfig.exe has not been executed, the only choice the Hardware Wizard will
present in the Interface dialog box will be Demo. See
Figure 7-3:
Clicking
From here, clicking
Selection!
Clicking
At this point, you will need to exit WinView/32 and run the RSConfig.exe program
which creates a file called PVCAM.INI. This file contains information required to
identify the interface/camera and is referenced by the Hardware Wizard when you are
setting up WinView/32 with the PhotonMAX for the first time.
Perform the following procedure:
1. If you have not already done so, close WinView/32 or WinSpec/32.
2. Verify the PhotonMAX is connected to the host computer and that it is powered on.
3. Launch RSConfig.exe from the Windows
Princeton Instruments menu or from the directory where you installed WinView/32.
4. When the RSConfig dialog is displayed, you can change the camera name to one
that is more specific or you can keep the default name, Camera1. See

Figure 7-4: Typical RSConfig Dialog: Camera1

Troubleshooting
NOTE:
This information in this section applies only to WinView/32
and WinSpec/32 Versions 2.5.19.0 and older.
Typical Hardware Wizard: Interface Dialog
Next > displays the Error Creating Controller. Error=129.
OK displays the
message.
OK again displays the Interface dialog shown in
Figure
The Wizard Can Not Continue Without a Valid
Figure
► ►
Start Programs
7-3.
dialog.
7-3.
►
Teledyne
Figure 7-4.
97