Startup; Shutdown; Device Setup Wizard - Teledyne FLIR Si124 Series User Manual

7
Getting started

7.3 Startup

1. Open the battery cover by turning the knob (1).
2. With the connectors first and the indicator lights (2) facing upwards, push the battery
into the battery housing.
3. Close the battery cover. Lock the cover by turning the knob.
4. Push the on/off button (3) to power on the camera.
When the power is on, the Power LED at the top side of the camera is red. If the Power
LED is flashing, the battery is discharged.

7.4 Shutdown

1. To power off the camera, push the on/off button until it clicks and rises up. You can al-
so pull out the battery from the battery housing.
2. The power is now off and the system will safely perform a shutdown.
3. The red Power LED at the top side of the camera will turn off when the shutdown is
complete.
If you encounter a problem with the system, a hard shutdown is performed by discon-
necting the battery power and waiting longer until the power led will turn off. If the shut-
down takes more than a 5 minutes after disconnecting the battery, contact FLIR Systems
for service.

7.5 Device setup wizard

The first time the FLIR Si124 is powered up, the device setup wizard is shown. The wiz-
ard will help you set up the most important settings needed for using the device. These
settings can be changed later through the settings menu. Please see the appropriate
section of the Settings below for details.
#T810536; r. AF/91009/91009; en-US
11