Port Commands Set - Advantech EKI-6558TI User Manual

no security
no security http
no security telnet
3.1.4

Port Commands Set

Table 3.5: Port Commands Set
Commands
interface fastEthernet
[Portid]
duplex
[full | half]
speed
[10|100|1000|auto]
no flowcontrol
security enable
no security
bandwidth type all
bandwidth type broadcast-multicast-
flooded-unicast
bandwidth type broadcast-multicast
bandwidth type broadcast-only
bandwidth in
[Value]
bandwidth out
[Value]
show bandwidth
state
[Enable | Disable]
Disable IP security function
G
Disable IP security of HTTP server
G
Disable IP security of telnet server
G
Level Description
Choose the port for modification.
G
Use the duplex configuration
command to specify the duplex
I mode of operation for Fast
Ethernet.
Use the speed configuration
command to specify the speed
mode of operation for Fast
I
Ethernet., the speed can't be set to
1000 if the port isn't a giga port..
Disable flow control of interface
I
Enable security of interface
I
Disable security of interface
I
Set interface ingress limit frame
type to "accept all frame"
I
Set interface ingress limit frame
type to "accept broadcast,
I
multicast, and flooded unicast
frame"
Set interface ingress limit frame
type to "accept broadcast and
I
multicast frame"
Set interface ingress limit frame
type to "only accept broadcast
I
frame"
Set interface input bandwidth. Rate
Range is from 100 kbps to 102400
kbps or to 256000 kbps for giga
I
ports,
and zero means no limit.
Set interface output bandwidth.
Rate Range is from 100 kbps to
102400 kbps or to 256000 kbps for
I
giga ports,
and zero means no limit.
Show interfaces bandwidth control
I
Use the state interface
configuration command to specify
the state mode of operation for
I
Ethernet ports. Use the disable
form of this command to disable
the port.
29
switch(config)#no security
switch(config)#no security http
switch(config)#no security telnet
Example
switch(config)#interface fastEthernet 2
switch(config)#interface fastEthernet 2
switch(config-if)#duplex full
switch(config)#interface fastEthernet 2
switch(config-if)#speed 100
switch(config-if)#no flowcontrol
switch(config)#interface fastEthernet 2
switch(config-if)#security enable
switch(config)#interface fastEthernet 2
switch(config-if)#no security
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type all
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type broadcast-
multicast-flooded-unicast
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type broadcast-
multicast
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type broadcast-only
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth in 100
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth out 100
switch(config)#interface fastEthernet 2
switch(config-if)#show bandwidth
switch(config)#interface fastEthernet 2
switch(config-if)#state Disable
Chapter3