Table of Contents
Advertisement
Watchdog Timer Programming Procedure
To program the watchdog timer, users must execute a program that writes a value to
the I/ O port address 943/944 (hex) to enable/disable. This output value represents
the time interval. The value range is from 01 (hex) to FF (hex), and the related time
interval is
1 to 255 seconds.
Data
Time Interval
01
02
03
04
...
3F
63 sec
The countdown starts by writing a value to LPC address 0x943. The countdown can
be stopped by reading 0x944. To refresh the counter, only a value has to be written
again to 0x943. If the counter expires, the watchdog is reset and the state machine
goes back to IDLE state.
MIC-3399 User Manual
1 sec
2 sec
3 sec
4 sec
84
Advertisement
Table of Contents
