JLG 1532E2 Service & Maintenance page 34

SECTION 2 - PROCEDURES
1. Special Bolts
2. End Cover
3. Seal Ring-Commutator
4. Seal Ring
5. Commutator Ring
6. Commutator Ring
7. Manifold
8. Rotor Set
8A.Rotor
5. If the end cover (2) is equipped with shuttle valve
components, remove the two previously loosened
plugs (21).
2-22
8B. Stator or Stator Vane
8C. Vane
8D. Stator Half
9. Wear Plate
10. Drive Link
12. Coupling Shaft
13. Bearing/Bushing, Inner
14. Thrust Washer
15. Thrust Bearing
Figure 2-15. Parker Drive Motor
BE READY TO CATCH THE SHUTTLE VALVE OR RELIEF VALVE
COMPONENTS THAT WILL FALL OUT OF THE END COVER
VALVE CAVITY WHEN THE PLUGS ARE REMOVED.
NOTE: The insert and if included the orifice plug in the end
– JLG Sizzor –
16. Seal
17. Back-up Washer
18. Housing
18A. O-Ring
19. Bearing/Bushing, Outer
20. Dirt & Water Seal
21. Plug
cover (2) must not be removed as they are serviced
as an integral part of the end cover.
3120855