Wheel Removal Procedure - Linhai LH400ATV-2B Owner's/Operator's Manual

16. MAINTENANCE
lbs/20N.m).
3. Remove fill plug and add 10 ounces(300ml) of SAE 80W/90 GL5. Weight
Gear Lubricant and inspect oil level. Oil level should be kept even with the
center of the drill point (approximately below the top of the fill hole).
4. Reinstall the fill plug. Tight securely (24.5 ft. lbs/35N.m).
5. Check for leaks.
WARNING
Operating your ATV with worn tires, improperly inflated tires, non-standard
tires or improperly installed tire will affect vehicle handling which could cause
an accident resulting in serious injury or death.
Follow the safeguards listed below to prevent this type of situation.
Important Safeguards
Maintain proper tire pressure according to charts below. Improper tire inflation
may affect ATV maneuverability.
Do not use improper tires. The use of non-standard size or type tires may
affect ATV handling.
Make certain the wheels are installed properly. If wheels are improperly
installed it could affect vehicle handling and tire wear.

Wheel Removal Procedure

1. Stop the engine, place the transmission in gear and lock the parking brake.
2. Loosen the wheel nuts slightly.
3. Elevate the side of the vehicle by placing a suitable stand under the footrest
frame.
4. Remove the wheel nuts and remove the wheel.
Tire Pressure
front
35kPa/5PSI
Wheel Installation
OWNER'S/OPERATOR'S MANUAL
LH400ATV-2B
rear
35kPa/5PSI
08.0
16-21