Handlebar Adjustment; Wheel Nut Torque Specifications - Linhai LH400ATV-2B Owner's/Operator's Manual

OWNER'S/OPERATOR'S MANUAL
LH400ATV-2B 08.0
16. MAINTENANCE
WARNING
Improper adjustment of the handlebars or incorrect torque of the adjuster block
tightening bolts can cause limited steering or loosening of the handlebars,
resulting in loss of control and possible serious personal injury or death.

Handlebar Adjustment

Your ATV has handlebars
which can be adjusted for
your personal fit.
1. Remove the handlebar cover.
2. Loosen the four bolts.
3. Adjust handlebar to desired
height. Be sure handlebars do
not hit gas tank or any other part
of machine when turned fully to left or right.
4. Torque handlebar adjuster block to 10-12 ft.Ibs(14-16Nm).
NOTE: Tighten bolts so there is an equal gap at the front and rear of the
handlebar block. Improper gap will result in improper fit of upper pod.
The following items should be checked occasionally for tightness; or if they
have been loosened for maintenance service.
Wheel Nut Torque Specifications（On Independent Suspension model ）
Bolt Size Specification
Front （ALUMINIUM
69Ft.Lbs 95N.m
16-11