Remove the LCD panel
Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 35
"Remove the LCD module" on page 46
"Remove the LCD bezel" on page 48
Step 1.
Pull out two pieces of the removable tape and remove four screws. Then, lift the LCD panel.
Figure 31. Pull out two pieces of the removable tape and remove four screws
Screw specifications
M2 × L3
Step 2.
Peel back the mylar, disconnect the EDP cable, and remove the LCD panel.
Figure 32. Disconnect the EDP cable and remove the LCD panel
Number of screws
4
.
Chapter 5
Removing a FRU or CRU
49