Establishing An Ethernet Connection - Extreme Networks ExtremeRouting SLX 9640 Installation Manual

Initial Setup and Verification
If you are going to use an IPv6 address, enter the network information in colon-separated notation
as prompted after the ipv6 address operand.
device(config)# interface Management 1
device(config-Management-1)# no ip address dhcp
device(config-Management-1)# ipv6 address \
fd00:60:69bc:832:e61f:13ff:fe67:4b94/64
5. Return to privileged EXEC mode by entering exit .
device(config)# exit
device#
6. To display the configuration, use the show running-config interface Management
command.
device# show running-config interface Management 1
interface Management 1
no ip address dhcp
ip address 10.24.85.81/20
ipv6 address fd00:60:69bc:832:e61f:13ff:fe67:4b94/64
!

Establishing an Ethernet connection

After using a serial connection to configure the IP addresses for the device, you can connect the active
management module to the local area network (LAN).
Note
Connecting interface modules to a private network or VLAN is recommended.
After establishing an Ethernet connection, you can complete the device configuration using a serial
console connection, Telnet connection, or existing management applications.
Perform the following steps to establish an Ethernet connection to the device.
1. Remove the shipping plug from the Ethernet port on the active management module.
The active management module has the LED labeled ACTIVE on the front panel illuminated in blue.
ExtremeRouting SLX 9640 Hardware Installation Guide
Establishing an Ethernet connection
59