NETGEAR CGD24Nv2 User Manual page 62

DOCSIS 2.0 Advanced Cable Gateway CGD24N v2 User Manual
2. In the main menu, under Advanced, select LAN IP. The LAN IP screen displays.
Figure 5-8
3. Enter the following LAN IP settings:
• LAN IP Address. Enter the LAN IP address that you would like to assign for your
gateway in dotted decimal notation. The factory default settings is 192.168.0.1.
• Subnet Mask. Enter the network number portion of an IP address. Unless you are
implementing subnetting, use 255.255.255.0 as the subnet mask.
• DHCP Server. The gateway is set up by default as a Dynamic Host Configuration
Protocol (DHCP) server, which provides the TCP/IP configuration for all the computers
that are connected to the gateway. You can change the default setting.
– Yes. Select this settings to enable the DHCP server on the gateway and assign IP
addresses to computers on your LAN automatically.
– No. Select this settings to assign IP addresses manually, or if you have another DHCP
server on your network.
Note: If you disable the DHCP server, you will need to assign to your PC a
5-14
static IP address to reconnect to the gateway and enable the DHCP
server again.
v1.0, August 2009
Customizing Your Network