NETGEAR CGD24Nv2 User Manual page 47

Running the Ping Diagnostic Utility
You can use the Diagnostics screen to test connectivity to a PC using the ping command.
To start a ping test:
1. Log in to the gateway as described in
2. In the main menu, under Maintenance, select Diagnostics. The Diagnostics screen displays.
Figure 4-6
3. Under Ping Test Parameters, enter the following settings:
• Ping Target. Enter the IP address of the computer that you would like to ping.
• Ping Size. Enter the size of the ping packet.
• No. of Pings. Enter the number of times you would like to ping the computer.
• Ping Interval. Enter the time you would like to wait between the pings.
4. Click Start Test.To stop the test while in progress, click Abort Test.
5. To see the results of the ping test, click REFRESH. To clear the test results after the test has
completed, click Clear Test.
Managing Your Network
DOCSIS 2.0 Advanced Cable Gateway CGD24N v2 User Manual
"Logging in to the Gateway" on page
v1.0, August 2009
1-5.
4-7