NETGEAR CGD24Nv2 User Manual page 52

DOCSIS 2.0 Advanced Cable Gateway CGD24N v2 User Manual
2. In the main menu, under Advanced, select Wireless Settings.
Figure 5-2
3. Click the Setup Access List button to display the Wireless Card Access List screen.
Note: If you are configuring the gateway from a wireless computer, make sure to add
your computer's MAC address to the Access List. Otherwise you will lose
your wireless connection when you click Apply. You must then access the
gateway from a wired computer, or from a wireless computer that is on the
access control list, to make any further changes.
The Access List table displays a list of wireless clients that will have access to the wireless
network when the list is enabled.
4. Adjust the access list as needed for your network. You can add a devices to the access list
using either one of the following methods:
• If the computer is in the Connected Wireless Devices table, click the radio button of that
computer to capture its MAC address. Then click Add.
5-4
v1.0, August 2009
Customizing Your Network