NETGEAR CGD24Nv2 User Manual page 14

DOCSIS 2.0 Advanced Cable Gateway CGD24N v2 User Manual
You can use the LEDs to verify connections.The following table lists and describes each LED on
the front panel of the Advanced Cable Gateway.
Table 1-1. LED Descriptions
LED
Power • On: Power is supplied to the gateway.
• Off: Power is not supplied to the gateway.
Downstream • Blink: Data is being received from the cable interface.
Traffic • Off: The cable interface is idle.
Upstream • Blink: Data is being transmitted to the cable interface.
Traffic • Off: The cable interface is idle.
Cable Link • On (green): Configuration of the cable interface by your cable service provider is
complete.
• Off: Configuration of the cable interface is still in progress.
Wireless • On: The wireless access point is operating normally.
• Blink: Data is being transmitted or received on the wireless interface.
• Fast blink: The gateway attempts to establish a connection to a wireless client through
Wi-Fi Protected Setup (WPS).
• Off: The wireless access point is disabled.
LAN • On (green): The port has detected link with a 100 Mbps device.
(Local Area • Blink (green): Data is being transmitted or received at 100 Mbps.
Network) • On (yellow): The port has detected link with a 10 Mbps device.
• Blink (yellow): Data is being transmitted or received at 10 Mbps.
• Off: No link is detected on this port.
1-2
Description
Connecting the Gateway to the Internet
v1.0, August 2009