NETGEAR CGD24Nv2 User Manual page 31

To use a PIN to add a WPS client:
1. Log in to the gateway as described in
2. In the main menu, under Setup, select Add WPS Client, and then click Next.
Figure 2-6
3. Select the PIN (Personal Identification Number) radio button and then click Next.
4. Go to the client wireless computer. Run a WPS configuration utility. Follow the utility's
instructions to generate a PIN. Take note of the client PIN.
5. Enter the client's PIN in the Add WPS Client screen of the gateway and then click Next.
• The screen displays the progress as the gateway tries to communicate with the client for 4
minutes.
• While the gateway attempts to establish a connection, you can stop this process by
clicking Cancel.
6. Go back to the gateway screen and check the WPS status:
• Success. A connection is established. The gateway has generated an SSID, implemented
WPA/WPA2 wireless security (including a PSK security password) on the gateway, and
has sent this configuration to the wireless client.
• Failure. No connection is detected, and no SSID or security settings are configured on the
gateway.
Note the new SSID and WPA/WPA2 password for the wireless network. You can view these
settings in the Wireless Settings screen. See
and Security" on page
To access the Internet from any computer connected to your gateway, launch a browser such as
Microsoft Internet Explorer or Mozilla Firefox. You should see the gateway's Internet LED blink,
indicating communication to the ISP.
Wireless Configuration
DOCSIS 2.0 Advanced Cable Gateway CGD24N v2 User Manual
"Logging in to the Gateway" on page
"Manually Configuring Your Wireless Settings
2-3.
v1.0, August 2009
1-5.
2-11