Operating Mode - Elesa DD51-E Instructions For Use Manual

All manuals and user guides at all-guides.com
DD51-E

7. Operating mode

7.1 Absolute / incremental measuring mode selection
Press the key to select the absolute or incremental
measuring mode.
The measuring mode selected is shown on the display by
the symbols:
- ABS : absolute measuring mode
- REL : incremental measuring mode
_ _ 0 _ _
It is possible to change the key function by
setting the parameter _ _ 0 _ _
The available options are:
- ArCLr (default): passing from ABS to REL the
counter is set to zero.
- Ar : passing from ABS to REL the counter is not set to
zero. In this case, the counter is set to zero by pressing
+ .
- OFF : the key
changing the selected measuring mode.
To program the parameters listed above, see paragraph 8.2.
7.2 Unit of measure selection
Press the key to select the unit of measure needed. The
options available are millimeters, inches and degrees.
The measuring mode selected is shown on the display
by the symbols:
- mm : millimeters
EN
6
Direct drive electronic position indicators
is disabled and does not allow
- INCH : inches
Models all rights reserved in accordance with the law.
- D : degrees
Always mention the source