Operating Mode; Absolute / Incremental Measuring Mode Selection; Measure Unit Selection - Elesa DD52R-E Operating Instructions Manual

DD52R-E
(GN 9053)

7 Operating mode

7.1 Absolute / incremental measuring mode selection

Press the key
The measuring mode selected is shown on the display by the symbols:
- ABS : absolute measuring mode
- REL : incremental measuring mode
_ _ 0 _ _ _
It is possible to change the key function by chosing one of
the available options in the voice menu _ _ 0 _ _ _
The available options are:
- ArCLr (default): passing from ABS to REL the counter is set to zero.
- Ar : passing from ABS to REL the counter is not set to zero. In this case, the
counter is set to zero by pressing
- OFF : the key
measuring mode.
To program the parameters listed above, see cap. 8.

7.2 Measure unit selection

Press the key
millimeters, inches and degrees.
The measuring mode selected is shown on the display by the symbols:
- mm : millimeters
0 _ _ _ _ _
It is possible to change the key function by chosing one of
the available options in the voice menu 0 _ _ _ _ _
The available options are:
- ALL (default): units of measure that can be selected: mm, inch, degree
- nodEG : units of measure that can be selected: mm, inch
- OFF : the key is disabled and does not allow changing the selected measuring mode.
To program the parameters listed above, see cap. 8.
Modelle, alle Rechte vorbehalten in Übereinstimmung mit dem Gesetz.
Bei Reproduktion der Zeichnungen, bitte immer Quellenangabe.
- DD52R-E-RF
(GN 9153)
to select the absolute or incremental measuring mode.
is disabled and does not allow changing the selected
to select the unit of measure needed. The options available are
- INCH : inches
+
.
- D : degrees
DE
11