Operating Mode - Elesa MPI-R10 Operating Instruction

MPI-R10

7. Operating mode

7.1 Absolute / incremental measuring mode selection
ABS-REL
Press the key
The measuring mode selected is shown on the display by the symbols:
- ABS : absolute measuring mode.
- REL : incremental measuring mode.
It is possible to change the key
(see cap.8.3).
The available options are:
- ArCLr (default): when relative measurement is selected the value is always
reset to zero.
- Ar : passing from ABS to REL the relative measurement is not reset to zero.
- OFF : the key is disabled and does not allow changing the selected measuring
mode.
7.2 Unit of measure selection
mm-inch
Press the key
The options available are millimeters, inches and degrees.
The measuring mode selected is shown on the display by the symbols: mm for
millimeters, INCH for inches and with the ° suffix for degrees
It is possible to change the key
(see cap.8.3).
The available options are:
- ALL (default): units of measure that can be selected: mm, inch, degree
- nodEG : units of measure that can be selected: mm, inch
- OFF : the key is disabled and does not allow changing the selected measuring
mode.
Models all rights reserved in accordance with the law.
Always mention the source when reproducing our drawings.
to select the absolute or incremental measuring mode.
ABS-REL
to select the unit of measure.
mm-inch
Magnetic measuring system
function by the menu voice _ _ 0 _ _ _ _
function by the menu voice 0 _ _ _ _ _ _
EN
11