Turning On The System; Turning Off The System; Operating Mode; Absolute / Incremental Measuring Mode Selection - Elesa DD51-E Operating Instructions Manual

DD51-E
(GN 9054)
+
>

6 Turning on the system

After reading and understanding the section "Safety
Instructions", proceed by switching on the indicator.
Turn the indicator on hold
The display will light up and the indicator will be ready
to be used.
6.1 Turning off the system (only for storage)
To turn the system off enter the programming mode, select
the rESEt parameter then press the key
point, press the button
will turn off and the indicator will go into into sleep mode.

7 Operating mode

7.1 Absolute / incremental measuring mode selection

Press the key
measuring mode.
If the incremental measuring mode is selected, the symbol
REL is shown on the display.
EN
10
- DD51-E-RF
Programmable with one of
the following options (see
the
_ _ 0 _ 0
menu – cap. 8.3):
[DEFAULT]: the
L_OrG
key combination sets the
absolute value to the sum of
the parameters Origin and
Offset.
: the key combination is
OFF
not assigned to any function
in the operating mode.
To turn on the indicator, hold
then press the key
After the start-up sequence
the indicator will be ready to
be used (see cap. 6)
to select the absolute or incremental
Models all rights reserved in accordance with the law. Always mention
(GN 9154)
voice of the
then press the key
for 5 seconds; the display
the source when reproducing our drawings and photos.
N/A
N/A
. At this
.