Table of Contents
Advertisement
24. Long-Focus Speed Proportion
25. Included 24VAC power supply
26. Communication
27. Camera Menu Operation
28. IP66 for Outdoor Use
29. Operating Humidity
30. Heater Operation
31. Operating Temperature
32. Video Connection
33. Power
INSTALLATION AND OPERATION
This symbol is intended to alert the user to the presence of important operating and
maintenance (servicing) instructions.
This symbol is intended to alert the user to the presence of uninsulated "dangerous
voltage" within the product's enclosure that may be of sufficient magnitude to constitute a
risk of electrical shock.
CAUTION: To reduce the risk of electrical shock do not remove the cover or back of this
unit. No user serviceable parts are inside.
CAUTION: To prevent electric shocks and risk of fire hazards, do not use other than
specified power source.
1. UNPACKING and HANDLING
Each unit is shipped factory tested. Minor assembly is required.
Ensure that all accessories are removed from the container before discarding packing material
2. MECHANICAL INSPECTION
Inspect the front and rear of the equipment for shipping damage. Make sure the equipment is
clean, and no connectors are broken, damaged, or loose. If equipment appears to be damaged
or defective please contact your distributor or SecurityTronix at 1-610-429-1511 for assistance.
3.
SPECIAL ATTENTION
a. The installer must comply with electrical safety standards. There must be sufficient
space between the camera's power supply and video line and any high voltage
equipment and/or cables.
b. To help ensure the camera's life and proper operation do not point the camera towards
the sun or strong light.
c. Do not install the camera in an environment where the temperature is above 122 F.
V2.0 5/1412
Yes
Yes
RS485(+/-)
Yes
Yes
95%
42ºF on; 57ºF off
-40ºF - 122ºF
BNC coaxial
24VAC @3A, 35W
3
Advertisement
Table of Contents
