Download Print this page

Unpacking And Handling; Mechanical Inspection; Special Attention; Wiring Connections - Security Tronix ST-DLI6502812-JBX-B Installation Manual

Vandalproof infrared color camera with integrated junction box

Advertisement

1. UNPACKING and HANDLING

Each unit is shipped assembled and factory tested.
Ensure that all accessories are removed from the container before discarding packing material

2. MECHANICAL INSPECTION

Inspect the front and rear of the equipment for shipping damage. Make sure the equipment is
clean, and no connectors are broken, damaged, or loose. If equipment appears to be
damaged or defective please contact your distributor or SecurityTronix at 1-610-429-1511 for
assistance.
3.

SPECIAL ATTENTION

a. The installer must comply with electrical safety standards. There must be sufficient
space between the camera's power supply and video line and any high voltage
equipment and/or cables.
b. To help ensure the camera's life and proper operation do not point the camera
towards the sun or strong light.
c. Do not install the camera in an environment where the temperature is above 113 F.
The camera should be installed in a cool and spacious environment.
d. Do not install the camera near a magnetic field or a high-power motor.
e. Only use a dry cloth to clean the camera. If there is dirt that is difficult to remove wipe
gently with a mild detergent. Never use strong or abrasive detergents.
f.
A 12VDC 500mA power supply must be used. AC power cannot be applied. Using a
power supply other than 12VDC 500mA will damage the camera.
g. Only qualified installers are allowed to install, test and disassemble the camera.
h. The IR LED angle and lens viewing range are adjusted at the factory. Any change to
the camera's lens will affect image quality.
i.
The camera is a low voltage product. If installed outdoors proper safety and
lightening grounding are required.

4. WIRING CONNECTIONS

a. Connect the power supply's DC plug to the camera's power outlet.
b. Connect the camera to the monitor with a 75Ω coaxial video cable.
c. Connect power supply's AC plug to a suitable AC power outlet.
d.
Adjust the lens direction according to the required surveillance area and environment.
V1.0 12-23-13
INSTALLATION AND OPERATION
3

Advertisement

loading

This manual is also suitable for:

St-dli6502812-jbx-w