Table of Contents
Advertisement
2.4.2.1 Absolute mode
ABS
(B) [14.000]
(C) [37.000]
(D) [62.000]
2.4.2.2 Incremental mode
"ABS" off
First method:
(B) [14.000]
(C) [23,000]
(D) [25,000]
Note:
Second method:
-14
(B) [0.000]
-23
(C) 0.000
-25
(D) [0.000]
Set the dro in absolute mode
Move the axis until the display reads [14.000] (B position) and drill the hole.
Move the axis until the display reads [37,000] (C position) and drill the hole.
Move the axis until the display reads [62,000] (D position) and drill the hole.
The displayed position value is always referred to the preset part zero
(datum).
Set the dro in incremental mode. ABS LED off
Presetting incremental zero after each drill.
Starting at point A.
Move the axis until the display reads [14.000] (B position) and drill the hole.
Set the X axis to zero. See note.
Move the axis until the display reads [23,000] (C position) and drill the hole.
Sets the X axis to zero. See note.
Move the axis until the display reads [25,000] (D position) and drill the hole.
If installation parameter PAR11=1, just press the axis key, ([X]) in this case, to
zero the axis.
Presetting the relative distance with respect to the next hole.
Starting at point A
Preset the relative distance to the next hole. See note.
Move the axis until the display reads [0.000] (B position) and drill the hole.
Preset the relative distance to the next hole. See note.
Move the axis until the display reads [0.000] (C position) and drill the hole.
Preset the relative distance to the next hole. See note.
Move the axis until the display reads [0.000] (D position) and drill the hole.
V0703 - 10i / 20i - Installation/Operation - DRO operation - (9/29)
Advertisement
Table of Contents
