Table of Contents
Advertisement
3.2 Rear panel
On the back of the unit the following items may be found:
Some of the following connectors might not be available depending on specific
models:
UL seal
CE seal (see "CE seal" page 24)
(12/29) - DRO installation - Installation/Operation - 10i / 20i - V0703
1. Three-prong power connector for AC and ground connection.
2. M6 mm terminal for general machine ground connection.
3. Mounting bracket
X1.- SUB-D HD type 15-pin female connector for 1st axis feedback device.
X2.- (20i). SUB-D HD type 15-pin female connector for 2nd axis feedback
device (scale or encoder).
In order to comply with UL standards, this unit must be connected in the final
application using a listed detachable cord set (BLEZ) with a molded three-
prong plug and a suitable fitting to be connected to the equipment, rated
minimum 300 V AC. The cord type shall be SO, SJO or STO. Suitable Strain
Relief means must be provided in the cord set to assure the connection of the
plug and the fitting.
Advertisement
Table of Contents
