Step 3: Power On The Device - Proxim ORiNOCO AP-9100 Hardware Installation Manual

Ceiling Mounting:
1. Place the mounting plate on the T-bar ceiling such that the embossed letter 'L' is at the top-center position and the
vent-holes are facing your left hand side.
2. Fasten the mounting plate by using a pair of plastic anchors and screws provided with the product package.
3. Hold the device with its rear panel facing the mounting plate, such that the vent-holes on the device and the
vent-holes on the mounting plate rest on each other.
4. Align the two keyholes on the device with the two holders on the mounting plate.
5. Carefully, slide the device towards your right hand side, until the holders on the mounting plate fasten securely onto
the keyholes of the device.
Mounting AP- 9100 to AP-800/AP-8000 mounting plate (Optional)
In case, you are mounting AP-9100 to an already installed AP-800/AP-8000
following steps.
Wall Mounting:
1. Hold the device such that the 'Reload' is towards your right hand side and the 'LEDs' towards left hand side.
2. Align the two keyholes on the device with the two holders on the mounting plate.
3. Carefully, slide down the device until the holders on the mounting plate fasten securely onto the keyholes of the
device.
Ceiling Mounting:
1. Hold the device such that the rear panel of the device is facing the mounting plate, with 'Reload' towards your right
hand side and 'LEDs' towards left hand side.
2. Align the two keyholes on the device with the two holders on the mounting plate.
3. Carefully, slide the device backwards until the holders on the mounting plate fasten securely onto the keyholes of the
device.
: Ensure that the mounting plate is fixed in the similar fashion, as described in AP-800/AP-8000 mounting procedures
Installation
(See

2.4.5.3 Step 3: Power On the Device

To power on the device, plug in the power cord into a power outlet. There is no ON/OFF switch on the device. To disconnect
power:
•
Unplug the power cable from the power socket of the device, if using power adapter.
®
ORiNOCO 802.11n & 802.11ac Access Points - Hardware Installation Guide
Figure 2-14 Ceiling Mounting
Procedure).
Hardware Overview and Installation
Mounting Plate
(P/N 67439), then follow the
28