Table of Contents
Advertisement
Ceiling Mounting:
1. Hold the device such that the rear panel of the device is facing the mounting plate, with 'Reload' towards your right
hand side and 'LEDs' towards left hand side.
2. Align the two keyholes on the device with the two holders on the mounting plate.
3. Carefully, slide the device backwards until the holders on the mounting plate fasten securely onto the keyholes of the
device.
: Ensure that the mounting plate is fixed in the similar fashion, as described in AP-800/AP-8000 mounting procedures
Installation
(See
2.3.5.3 Step 3: Power On the Device
To power on the device, plug in the power cord into a power outlet. There is no ON/OFF switch on the device. To disconnect
power:
•
Unplug the power cable from the power socket of the device, if using power adapter.
•
Unplug the RJ45 connector from the Data & Power Out port on the DC injector, if using the Gigabit Ethernet PoE.
2.3.5.4 Step 4: View LEDs
When the device is powered on, it performs startup diagnostics. When startup is complete, the LEDs show the operational
state of the device. Tabulated below is the behavior of the four LEDs on the device.
LED
Symbol
Power
LED
Ethernet
LED
2.4 GHz
LED
5 GHz
LED
: When the Reload button is pressed, the Power LED glows amber.
®
ORiNOCO
802.11n & 802.11ac Access Points - Hardware Installation Guide
Procedure).
Glows green when the AP-8100 device is switched ON.
• Glows green when the AP-8100 device is connected to a 1 Gbps link.
• Blinks green when the AP-8100 device traffic is being transmitted or
received on the 1 Gbps link.
• Glows amber when the AP-8100 device is connected to a 100 Mbps
link.
• Blinks amber when the AP-8100 device traffic is being transmitted or
received on the 100 Mbps link.
• Glows red when the AP-8100 device is connected to a 10 Mbps link.
• Blinks red when the AP-8100 device traffic is being transmitted or
received on the 10 Mbps link.
• Glows green when the AP-8100 device wireless interface 2 is in
operational state.
• Blinks green when the AP-8100 device wireless traffic is being
transmitted or received.
• Glows green when the AP-8100 device wireless interface 1 is in
operational state.
• Blinks green when the AP-8100 device wireless traffic is being
transmitted or received.
Hardware Overview and Installation
Behavior
Color
22
Advertisement
Table of Contents
