Manual Range Switch - Fuji Electric ZPAH Instruction Manual

6.1.2 Manual range switch

range.)
range.
Note) If "RR" or "AR" is selected as range
switch mode, this operation cannot
be performed.
The ranges for O
O correction average value, and
2
O average value are automatically
2
switched according to the instanta-
neous value range switch settings.
(Same as for "RR" or "AR".)
To close the setting
ESC
Press the
switch mode or range switch operation or stop
the operation in the middle. The setting
operation is made invalid and the previous
screen appears.
Range identification contact operation
The range identification contact output corresponding to each Ch (component) is closed when
Range 1 is active, and open when Range 2 is active, no matter.
If the measurement value is held by remote contact input or during calibration routine and
range switch conditions are met, the contact will change position only after the hold codition
is removed.
INZ-TN2ZPAH-E
ENT
key.
key. (The
ENT
correction value,
2
key to end the setting of range
Switch Ranges
Ch1
MR
CO
2
Ch2
AR
CO
Switch Ranges
Ch1
MR
CO
2
-
Ch2
AR
CO
End of Range Switch
23
Select method of
switch ranges
with UP/DOWN and ENT
Back with ESC
Range1 0–10.00
vol%
Range2 0–20.00
vol%
Range1 0–500.0
ppm
Range2 0–2000
ppm
ENT
Select range
with UP/DOWN and ENT
Back with ESC
Range1 0–10.00
vol%
Range2 0–20.00
vol%
Range1 0–500.0
ppm
Range2 0–2000
ppm
ENT
( )