JLG 3394RT Service Maintenance Manual page 62

SECTION 3 - CHASSIS & SCISSOR ARMS
2. Install rotary group with cradle. Observe installation
position of swivel balls.
NOTE: Slightly grease swivel balls.
3. Mount sleeve and pressure ring in cradle stop. Insert
cradle stop.
NOTE: Stick with grease.
3-26
4. Mount Seeger snap ring. Opening of snap ring must
be on the opposite side of the control piston.
5. Fit pressure pins using an assembly aid. Pre-ten-
sion the spring using a suitable device.
6. Assemble piston with retaining plate. Oil piston and
slipper pad.
– JLG Sizzor – 3121133