JLG 3394RT Service Maintenance Manual page 172

SECTION 5 - JLG CONTROL SYSTEM
NOTE: When configuring an RT, the Machine Configuration must be completed before any Personality settings can be
changed. Changing the Personality settings first and then changing the Model of the Machine Configuration will cause
the Personality settings to return to default values.
Configuration Digit Setting
1
(MODEL)
2
(ENGINE)
3
(MARKET)
4
(TILT CUTOUT)
5
(GLOW PLUGS)
6
(LEVELING JACKS)
7
(POWER DECK)
8
(GENERATOR)
9
(FUNCTION CUTOUT)
5-18
Table 5-3. Machine Configuration Programming Information
0
1
2
3
0
1
2
3
4
5
0
1
2
3
4
0
1
0
1
2
3
4
5
6
7
0 No - Leveling Jacks not installed on vehicle.
1 YES – Leveling Jacks are installed on vehicle.
0 NONE – Power Deck Extensions not installed on vehicle.
1 FRONT – Power Deck Extension is installed on the Front of the vehicle.
2 DUAL – Power Deck Extensions are installed on the Front and Rear of the vehicle.
0 NOT INSTALLED – Generator is not installed on the vehicle.
1 60HZ – Generator is installed and engine speed set for 2000RPM when enabled.
2 50HZ – Generator is installed and engine speed set for 1700RPM when enabled.
0 NOT INSTALLED – Vehicle is not equipped with a Function Cutout device.
1 DRV & LIFT UP – Vehicle is equipped with a Function Cutout device. Drive and Lift Up will
2 ALL FUNCTIONS – Vehicle is equipped with a Function Cutout device. All Functions will
Description
33RT 2WD
33RT 4WD
43RT 2WD
43RT 4WD
FORD EFI D/F
DEUTZ F3
FORD D/F (T2)
DEUTZ F3 (T2)
DEUTZ ECM
DUAL FUEL ECM - GM/PSI Engine
ANSI USA
ANSI EXPORT
CSA
CE
AUSTRALIA
NO - Tilt Cutout is not active
Yes - Tilt Cutout is active
(Screen only visible to CE Market)
NO GLOW PLUGS
5 SEC GLOW
10 SEC GLOW
20 SEC GLOW
30 SEC GLOW
40 SEC GLOW
50 SEC GLOW
60 SEC GLOW
be prevented when active.
be prevented when active.
– JLG Lift–
Default Number
1
4
0
1
5
0
0
0
0
3121133