6 Operation
6.1 Device overview and operating controls
Manual adjuster
Fig. 6-1: Location of operating elements
6.2 Indication with LEDs
The electric actuator with process controller
has a red and a yellow LED which indicate
the operating state of the actuator. The LEDs
are located underneath the transparent cover
on top of the actuator (see Fig. 6-1).
Î See the 'Operation' section for the blink-
ing pattern.
EB 5757-7 EN
Slider switch (red)
Travel indicator
Manual adjuster
6.3 Slider switch
The slider switch is used to switch between
two different control configurations and
parameters #1 and #2.
The slider switch points away from the
housing in position #1 and in position #2
towards the middle of the housing.
Operation
Serial interface
Cover/LEDs
6-1