Single Output; Enable Dual Output Function (Coordinating With Software) - Chroma 69225 Series User Manual

Regenerative Charge/Discharge Tester 69225/69212 Series User's Manual
2. The instrument charge/discharge adopts constant current mode,
3. Use Chroma provided output wire.
4. For optimum operation of the instrument, keep the external

2.4.1 Single Output

The system default is single output only CHG/DSG connection ports at upper side with
charge/discharge function. The CHG connection port at lower side is without function and the
wiring is invalid as Figure 2-2 shown.
Connect to charge/
discharge port of DUT.
Unused
2.4.2 Enable Dual Output Function (Coordinating with
Software)
If the system is set to dual output function as Figure 2-3 shown, it is need to enable dual
output function by the software first. The CHG/DSG at upper side is regarded as connection
port discharged by the battery and the CHG at lower side is regarded as connection port for
charging the battery.
2-6
don't operate it under open circuit status when setting output wire.
input/output wire and communication wire connected smoothly as
possible without bundling or twisting them.
Figure 2-2