Chroma 69225 Series User Manual page 27

Item Name
1 69200 CONTROL Input
2 69200 CONTROL Output It connects 69200-1 controller (OUT) via D-Sub.
3 ADDRESS
4 PARALLEL
5 TEMPERATURE
6
RMT SENSE
Charge/Discharge
7
8 CHARGE
9 AC INPUT
10 DC BUS
Table 1-4
It connects 69200-1 controller (IN) via D-Sub.
By using toggle switch to input channel number and set
terminator.
PIN Description
1 ADDRESS 1
2 ADDRESS 2
3 ADDRESS 3
4 ADDRESS 4
5 ADDRESS 5
6 ADDRESS 6
7 PARALLEL TERMINATOR
8 N/A
After connecting, the tester is with output parallel function
and output current is for current sharing.
It returns measurement temperature reading via
temperature sensor board.
It connects to load terminal for compensating drop which
caused by line resistance. Be sure connector terminal "+"
of RMT Sense line connects to "+" terminal on rear panel,
connector terminal "-" of RMT Sense line connects to "-"
terminal on rear panel. Don't connect polarity reversely.
Charge/discharge terminal on charge/discharge tester,
before plugging in please ensure RMT Sense line
connected. The system default is single output. If dual
output function is enabled (coordinating with software), this
terminal is discharge port.
This is charge port for charge/discharge tester when
enabling dual output function (coordinating with software).
Before plugging in please ensure RMT Sense line
connected. It doesn't be used if dual output function is
disabled.
The mains is inputted from the socket, the range is
100V~240V, 50/60Hz 150VA MAX.
This is input connection terminal for connecting A691101
output (420V).
Description
Overview
1-11