SHINOLA DETROIT Manual page 7

ACCUMULATED TIMING
Example
1 Start: start timing
2 Stop: e.g., 15 min. 5 sec. following 1
3 Restart: timing is resumed
*Stop: e.g., 13 min. 5 sec. following
4 3
The accumulated time = 28 min. 10 sec.
5 Reset: the three chronograph hands
are returned to their zero positions.
Please note:
4
* Following , the accumulation of the timing can be
continued by pressing push-button A
INTERMEDIATE OR INTERVAL TIMING
Example
1 Start: start timing.
2 Display interval:
e.g., 10 min. 10 sec. following 1 .
Timing continues in the background.
*
3 Making up the measured time:
the two chronograph hands are quickly
advanced to the ongoing measured time.
4 Stop: e.g., 28 min. 10 sec. following
5 Reset: the three chronograph hands
are returned to their zero positions.
Please note:
3
* Following , further intervals or intermediates can be
displayed by pressing (display interval / make up measured time, ...)
B
12
1
.
A
.
B
5
(Restart/Stop, Restart/Stop,...)
A
1 .
B
CHRONOGRAPH MODEL 5030.D
4
DESCRIPTION OF THE DISPLAY AND CONTROL BUTTONS
3
2
Please note:
Before using the chronograph functions,
please ensure that:
- the crown is in position
(= normal position).
- the three chronograph hands are
precisely at zero position following
activation of push-button B. If the hands
are not precisely at zero, their positions
must be adjusted. (See the chapter
Adjusting the Chronograph Hands to Zero .)
SETTING THE TIME
1 Pull out the crown to position III.
(The watch stops.)
4
1
Turn the crown until you reach the
2
correct time.
3 Push the crown back to position I.
SETTING THE DATE
Pull out the crown to position II.
1
(The watch continues to run.)
2
3
5
2 Turn the crown until the correct date appears.
3 Push the crown back to position I.
4 If setting the date between 9:00 p.m. and 12:00 a.m., follow steps 1
through 3, but be sure to set the date to the following day.
Center stop-second
I
Minute hand
Hour hand
Minute counter
Hour counter
13
Second hand
A
I
B
Date
1
I II III
2
3
1
I II
2
3