SHINOLA DETROIT Manual page 10

ACCUMULATED TIMING
Example
1 Start: start timing.
2 Stop: e.g., 15 min. 5 sec. following 1
3 Restart: timing is resumed.
*Stop: e.g., 10 min. 5 sec. following
4 3
The accumulated time = 25 min. 10 sec.
5 Reset: The three chronograph hands
are returned to their zero positions.
Please note:
* Following 4 , the accumulation of the timing can be
continued by pressing push-button A
INTERMEDIATE OR INTERVAL TIMING
Example
1 Start: start timing.
2 Display interval:
e.g., 10 min. 10 sec. following .
1
Timing continues in the background.
*
3 Making up the measured time:
the three chronograph hands are quickly
advanced to the ongoing measured time.
4 Stop: (Final time is displayed).
5 Reset: The three chronograph hands are
returned to their zero positions.
Please note:
3
* Following , further intervals or intermediates can be
displayed by pressing B (display interval / make up measured time, ...)
18
1
.
A
.
B
5
(Restart/Stop, Restart/Stop,...)
A
B
CHRONOGRAPH MODEL 5050.B
4
DESCRIPTION OF THE DISPLAY AND CONTROL BUTTONS
3
2
Please note:
Before using the chronograph functions,
please ensure that:
- the crown is in position
(= normal position).
- the four chronograph hands are
precisely at zero position following
activation of push-button B. If the
hands are not precisely at zero,
their positions must be adjusted.
(See the chapter Adjusting the
Chronograph Hands to Zero .)
SETTING THE TIME
1 Pull out the crown to position III.
(The watch stops.)
4
2 Turn the crown until you reach the
1
correct time.
3 Push the crown back to position I.
SETTING THE DATE
1 Pull out the crown to position II.
(The watch continues to run.)
2
2 Turn the crown until the correct date appears.
3
5
3 Push the crown back to position I.
4 If setting the date between 9:00 p.m. and 12:00 a.m., follow steps 1
through 3, but be sure to set the date to the following day.
Center stop-second
Minute hand
I
Hour hand
Minute counter
Hour counter
1 / Second counter
10
Big date
19
A
I
B
Second hand
1
I II III
2
3
1
II
2
3