Chapter 1: Introduction
Rear panel
AC Power input: 100-240 VAC, 60 VA, 50/60 Hz
Side panel
The following connectors are located at the right side of the device:
Connector of ECG cable
USB port for data export and software update
Built-in Battery
The electrocardiograph is equipped with a rechargeable battery. The battery will charge
automatically once you connect the system to the AC INPUT (whether the device is on or off).
When the battery is fully discharged, it takes about 5 hours to charge it. The system can run on a
fully-charged battery when the power cord is unplugged. Different types of the batteries used in
the system and their charge time are specified in "Technical Specification" section.
Warning
If the battery discharges in less than 1 hour, contact after-sales service to replace it.
Figure 1-5 Rear panel
Figure 1-6 Side panel
10