Table of Contents
Advertisement
Chapter 7 Adjustment and initial operation
Instruction
Please adjust the peeler plate as follows.
Step
1
2
3
4
4
Adjust peeler plate of bottom side labeling
The distance between peeler bar and bottom side of product (conveyor belt) is given
constructively.
Information on adjustment of peeler plate
The required label position on the product is adjusted via lateral adjustment of the labeler.
No.
1
Version: 15.01.14
Procedure
Add a product at the infeed passage of the labeling system.
Hazards from actively triggered movements. Keep away from moving parts.
Just start the base conveyor and then stop it when the product is in the area
of the peeler plate.
Loosen the clamping (Pos. 5, Fig. 7-4) and adjust the height of the peeler
plate according to the required criteria (information see above). Fix the
clamping again.
Adjust the lateral position to the product via crank (Pos. 4, Fig. 7-4).
Add more products at the infeed passage to check the adjustment.
.
Description
CRANK FOR LATERAL ADJUSTMENT
page 40 of 59
40002674 BTA Geset 117
Fig. 7-5: Adjust bottom peeler plate
GB
Advertisement
Table of Contents
