Table of Contents
Advertisement
Chapter 6 Installation and initial startup
Installation
Continuous operation with minimal wear and downtime can only be ensured when the
system is installed properly. Fine adjustments to the conditions of use are essential when
installing the system. These fine adjustments are adapted to the surrounding conditions.
To make these fine adjustments, detailed professional knowledge is necessary that arises
from experience with labeling systems.
This required professional knowledge cannot be completely communicated by the
operating instructions; therefore a Technician from the Bluhm Weber Group needs to
perform the installation or accept the labeling system in a final inspection. The warranty
does not cover damage or consequential damage arising from improper installation
lacking the necessary fine adjustments.
Requirements at the installation site
An enclosed and clean room.
Flat, solid base.
Any unevenness may not exceed 5 mm when stands from the Bluhm Weber Group
are used.
Sufficient bearing capacity: 1,500 kg/m².
Low vibration environment.
Sufficient lighting: 500 Lx.
No direct exposure to sunlight or a radiator.
The machine may not be operated within electrostatic or magnetic fields. This can
cause the controls to malfunction.
A proper energy supply according to the chapter, "Specifications" on page 22.
Placing the labeling system
The labeling station has to be adapted to the customer's conveying system in
position and height. The height of the system parts has to be ergonomically
designed according to the user's requirements.
The installed position must allow sufficient access for users and service
technicians. In particular at all times, the mains switch / plug must be freely
accessible to disconnect the power supply
Make sure that all fasteners are sufficiently tight.
Observe all of the items under "Intended use" in the chapter "Safety regulations".
Version: 15.01.14
page 30 of 59
40002674 BTA Geset 117
GB
Advertisement
Table of Contents
