Table of Contents
Advertisement
Chapter 7 Adjustment and initial operation
Adjust side guidance
The side guidances are used to determine the place at the conveyor where the product to
be labeled should be transported to. For side labeling, the adjustment is generally
centered to the base conveyor.
Information on adjustment of side guidance
The side guidances are adjusted by the star grips. The guidances have to be adjusted that
between product and side guiding is a crack of appr. 1-1,5 mm per side.
No.
1
2
3
Requirements
¥
Labeling system is turned off.
¥
2 sample products.
¥
No transportation of products.
Instruction
Please adjust the side guidance as follows.
Step
1
2
3
4
5
Version: 15.01.14
Description
STAR GRIP SIDE GUIDANCE
SIDE GUIDANCE WITH WEAR STRIP
DISTANCE = PRODUCT + 2-3 mm
Procedure
Loosen the star grips.
Open the side guidances and place one sample product at beginning and
end.
Adjust the side guidance to the required criteria (s. section above). Observe
a distance of 1 - 1,5 mm to the product. (In infeed passage this distance can
be adjusted larger.)
Tighten the star grips.
Check the adjustment by moving a sample product through the side
guidances. The sample product has to slide easily through the guidance at
each passage.
page 37 of 59
40002674 BTA Geset 117
Fig. 7-2: Side guidance
GB
Advertisement
Table of Contents
