Table of Contents
Advertisement
TECHNICAL DATA
The MEK 4 wire feed units is of enclosed construction with four- - wheel drive to the wire.
Power supply
Power requirement
Feed speed
Welding gun connection
Max. diameter of wire bobbin
Weight
Dimensions (l x w x h)
WARNING
There is a risk of tipping if the MEK 4 is fitted with a counterbalance arm. Secure the
equipment, especially if used on an uneven or sloping surface.
Limit the angle of rotation of the wire feed cabinet using the straps supplied.
When moving the equipment, do NOT pull on the torch.
MAINTENANCE
Regular maintenance is important in ensuring safe and reliable operation.
The feed unit
S
Clean and replace the wearing parts in the feed mechanism at regular intervals.
Do not set too high a pressure on the pressure rollers, as this can cause abnormal wear of
the pressure rollers,. the feed rollers and wire guide. Instructions for setting of the wire
feed pressure are on page 25.
The welding gun
S
Blow the wire guide clean with compressed air at regular intervals and clean the gas
nozzle.
cmek0de1
42 V 50 -- 60 Hz
300 VA
1.9 -- 25 m/min
EURO
300 mm
16 kg
645 x 240 x 480 mm
- - 24 - -
Hide quick links:
Advertisement
Table of Contents
