Advertisement

Quick Links

MEK 25
101103105107109111102021110025108024042106023061104022041100020040060001
Bruksanvisning
Brugsanvisning
Bruksanvisning
Käyttöohjeet
Instruction manual
Betriebsanweisung
0455 337 001
021113
Manuel d'instructions
Gebruiksaanwijzing
Instrucciones de uso
Istruzioni per l'uso
Manual de instruções
Ïäçãßåò ÷ñÞóåùò
Valid for serial no. 438- -xxx- -xxxx

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MEK 25 and is the answer not in the manual?

Questions and answers

Summary of Contents for ESAB MEK 25

  • Page 1 MEK 25 101103105107109111102021110025108024042106023061104022041100020040060001 Bruksanvisning Manuel d’instructions Brugsanvisning Gebruiksaanwijzing Bruksanvisning Instrucciones de uso Käyttöohjeet Istruzioni per l’uso Instruction manual Manual de instruções Betriebsanweisung Ïäçãßåò ÷ñÞóåùò 0455 337 001 021113 Valid for serial no. 438- -xxx- -xxxx...
  • Page 2 SVENSKA ..........DANSK .
  • Page 3 ENGLISH 1 DIRECTIVE ............2 SAFETY .
  • Page 4: Declaration Of Conformity

    DECLARATION OF CONFORMITY Esab Welding Equipment AB, S--695 81 Laxå, Sweden, declares that Wire feed unit MEK 25 from serial number 438 onwards, conforms to standard EN 60974--1, in ac- cordance with the requirements of directive (73/23/EEC) and appendix (93/68/EEC) and standard EN 50199 in accordance with the requirements of directive (89/336/EEC) and appendix (93/68/EEC).
  • Page 5: Technical Data

    INTRODUCTION A10- - MEK 25 is an intermediate wire feed unit for MIG/MAG--welding where the electrode is fed forward according to ESAB:’s A10--system By connecting an extension cable between the intermediate wire feed unit and the wire feed unit on the power source the working radius can be increased by up to 25 m.
  • Page 6: Technical Description

    TECHNICAL DESCRIPTION (1) Potentiometer for stepless control of the welding voltage. (2) Potentiometer for stepless control of the wire feed speed. Setting range 1--18m/min. (3) Remote switch for controlling the wire feed speed and voltage from a remote control unit. (4) Socket for connecting the remote control unit, 23--pole.
  • Page 7: Installation

    INSTALLATION WARNING! This product is intended for industrial use. In a domestic environment this product may cause radio interference. It is the user’s responsibility to take adequate precautions. Connecting the extension cable and the welding gun The extension cable is connected to connector (6). Connect the 14--pole sleeve plug on the extension cable’s control cable to the pin socket (7) and tighten the nut.
  • Page 8: Operation

    OPERATION Connect the return cable from the power source to the work piece. Set a suitable wire feed speed and voltage by using the potentiometers (1) and (2). You can now start to weld.. bm16d000 - - 36 - - bm16d12e...
  • Page 9: Order Number

    469 427--880 ORDERING OF SPARE PARTS Spare parts are ordered through your nearest ESAB representative, see back cover. When ordering spare parts, please state machine type and number as well as desig- nation and spare part number as shown in the spare parts list.

Table of Contents