Table of Contents
Advertisement
Available languages
Available languages
9049040
ASSEMBLY & INSTALLATION
Letter references in parenthesis (A) refer to the included Identification Key.
Dashed numbers in parenthesis (Fig. 1-1) refer to a specific point in an
illustration or image.
INSTALL EXTERNAL BATTERY PACK
WARNING! Avoid unintentional starts by ensuring the trigger lock (A) is
engaged before installing the battery pack.
1.
Check the battery power level before each use.
a.
The battery is not fully charged out of the carton. Charge the
battery before first use.
2.
Install the battery by aligning the rib on the battery with the groove
on the battery port and push forward until the latch clicks.
3.
Remove the battery by pushing the battery lock button and pulling the
battery free.
INSTALLING THE BLADE
1.
Turn the saw upside down.
2.
Twist the chuck (Fig. 1-1) clockwise to open.
The chuck will move to the left, creating
space for the blade.
2.
Insert the blade (E) into the chuck, with the
teeth pointing away from the saw.
3.
Release the chuck to close.
4.
Ensure that the blade is securely locked.
ADJUSTING THE FENCE
1.
Loosen the fence lock knob and slide the fence (H) to the desired
cutting width.
IMPORTANT! The ruler on the fence shows the approximate cutting width.
The fence can be removed completely if needed.
2.
Tighten the fence lock knob.
12
20V Li-ion Cordless Jig Saw
For technical questions call 1-800-665-8685
1-1
V1.0
Fig. 1
Advertisement
Table of Contents
