Assembly And Installation; Before Starting - Power Fist 9027814 Manual

V1.0
6. Position the cord so it is not be stepped on, tripped over or otherwise
subjected to damage or stress.
7. Do not wrap the cord around the tool, as sharp edges may cut insulation
or cause cracks if wound too tight. Gently coil cord and either hang on a
hook or fasten with a device to keep cord together during storage.
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the
missing part before operating. Failure to do so could result in a
malfunction and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Contents:
• Drill Head
• Column
ASSEMBLY & INSTALLATION

BEFORE STARTING

1. Remove the protective coverings from the base, the column and the head
assembly.
2. Strip the protective oil coat from the table and the column using
household grease removers.
3. Apply a coat of paste wax on the table and the column to prevent rust.
4. Wipe all parts thoroughly with a clean, dry cloth.
5. Clean the chuck' s tapered hole and the spindle nose to ensure that the
chuck will be seated properly. Use cleaning solvents if necessary.
Page 9
MINI BENCH-TOP DRILL PRESS
• Table
• Handle
• Pedestal Base
www.princessauto.com / 1-800-665-8685
9027814