Toshiba TS3000 Series Instruction Manual page 157

series Robot Controller
(b) Step 2: Range selection.
Move the main cursor by means of the ↓ key or ↑ key to change the selection
range. The following display then appears.
T R A N S S E L E C T I O N
. w o r l d
T R A N S 0 0 0 0 1
T R A N S 0 0 0 0 2
T R A N S 0 0 0 0 3
↓
T R A N S 0 0 0 0 4
T R A N S 0 0 0 0 3
• The entire data selected is displayed inversely.
• Either world coordinate, tool coordinate or work coordinate is not included in
the selection range.
• The main cursor indicates the data next to the selection range.
Keys operative in this mode and their operations are shown below.
Key
Used to widen the selection range upward.
↑
Used to widen the selection range downward.
↓
Used to widen the selection range upward on the screen
ALT + ↑
basis.
Used to widen the selection range downward on the screen
ALT + ↓
basis.
Cancels the range selection and returns the system to the
ESC
coordinate data directory display mode.
Operation of each menu is shown below.
Menu
[CUT] Used to save the data in the selection range in the cut buffer and
delete that data.
C U T
Descriptions
Descriptions
– 5-63 –
OPERATOR'S MANUAL
[ 4 / 1 1 ]
1 0
0
5
0
4
STE 80720