series Robot Controller
(b) Step 2:
Completes save.
Press the EXE key, and the system returns to the basic display as shown
below.
M O D E : T E A C H I N G / C O N T
E D I T
D E D I T
To cancel this function, press the ESC key. You can then continue editing.
(3) Cautions
•
When the data editor was started up from the program editor, the latter editor
also terminates after saving the program in the file.
•
In the data change mode (i.e., state where the cursor is on the command line),
the keys may be inoperative even if pressed. When this happens, select the
data display mode first, then press the keys.
S E L C T
– 5-17 –
OPERATOR'S MANUAL
L :
O :
2 0 %
M : F R E E
S : S T O P
R E S E T
F I L E
>
STE 80720