Pepperl+Fuchs FD0-VC-Ex4.FF Manual page 55

Valve coupler
Table of Contents

Advertisement

Parameter
CYCLE_SEL
MIN_CYCLE_T
MEMORY_SIZE
NV_CYCLE_T
FREE_SPACE
FREE_TIME
SHED_RCAS
SHED_ROUT
FAULT_STATE
SET_FSTATE
CLR_FSTATE
MAX_NOTIFY
LIM_NOTIFY
CONFIRM_TIME W
WRITE_LOCK
UPDATE_EVT
BLOCK_ALM
ALARM_SUM
ACK_OPTION
WRITE_PRI
WRITE_ALM
ITK_VER
SERIAL_NUM
SW_REV
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group • Tel.: Germany +49 621 776-0 • USA +1 330 4253555 • Singapore +65 67799091 • Internet http://www.pepperl-fuchs.com
Char.
W
Is used to display the block implementation method.
S
Shortest macro cycle which can be used by this device.
FF standard parameter. Not used.
FF standard parameter. Not used.
FF standard parameter. Not used.
FF standard parameter. Not used.
W
Period of time until a communication failure is recognised in the "RCas" mode.
S
W
Period of time until a communication failure is recognised in the "ROUT" mode.
S
Indicates whether or not the device global safety status was set. See
SET_FSTATE and CLR_FSTATE.
W
Is used to set the device global safety status.
S
W
Is used to reset the device global safety status.
S
Maximum number of not acknowledged alarm messages which can be man-
aged by the device.
W
Maximum number of not acknowledged alarm messages which are admitted.
S
Period of time during which an alarm is repeated unless acknowledged.
S
Indicates the position of the read-only switch.
This parameter is used to signal to the control system that a parameter identi-
fied by "S" was overwritten if the control system supports alarm messages.
This parameter is used to signal to the control system diagnosis messages dis-
played in BLOCK_ERR, if the control system supports alarm messages.
The current status of the alarm messages of the block.
W
Determines whether or not the alarms of the resource block must be acknowl-
S
edged.
Priority of the alarm messages which are released when setting and resetting
the read-only switch.
Alarm message which is released when setting and resetting the read-only
switch.
Versions number of inter operability test, which was used to test the device.
Serial number of device.
Version status of software in device.
Fieldbus Valve Coupler FD0-VC-Ex4.FF
Description
Copyright Pepperl+Fuchs, Printed in Germany
Resource block
55

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FD0-VC-Ex4.FF and is the answer not in the manual?

Table of Contents