Replacing The Raid Battery - Avaya S8800 Manual

Replace the Avaya S8800 Server and its components

Replacing the RAID battery

Removing the RAID battery
Before you begin
The RAID battery is located on top of the RAID controller card.
The RAID configuration data is preserved when you replace the battery.
About this task
Important:
Always use an electrostatic-discharge wrist strap or other grounding system when you work
inside the server. For more information, see
Procedure
1. Turn off the server and all attached devices.
2. Label and disconnect all power cords and external cables.
3. Remove the cover.
4. Disconnect the cable from the connector on the battery. Leave the other end of the
5. Squeeze the clip on the side of the battery to remove the battery from the battery
6. Put the old battery aside.
40 Maintaining the Avaya S8800 Server for Avaya Aura
cable connected to the battery carrier.
carrier. See the following figure.
1
2
Comments? infodev@avaya.com
Protecting against ESD damage
Battery
Battery carrier
®
Communication Manager
on page 10.
July 2012