Avaya S8800 Manual page 22

Replace the Avaya S8800 Server and its components
1
2
3
4
Removing the DIMM air baffle
About this task
You must remove the DIMM air baffle to replace or install a memory module.
Caution:
For proper cooling and airflow, replace the air baffle before you turn on the server. Operating
the server with a missing air baffle might damage server components.
Important:
Always use an electrostatic-discharge wrist strap or other grounding system when you work
inside the server. For more information, see
Procedure
1. Turn off the server and all attached devices.
2. Label and disconnect all power cords and external cables.
3. Remove the cover.
4. Lift the DIMM air baffle out of the server. Make sure that the pin comes out of the
22 Maintaining the Avaya S8800 Server for Avaya Aura
pin hole on the system board to the left of DIMM connector 8. See the following
figure.
Comments? infodev@avaya.com
DIMMs for microprocessor 2
DIMMs for microprocessor 1
Back of server
Front of server
Protecting against ESD damage
®
Communication Manager
on page 10.
July 2012